EN
2
OVERVIEW
1. Wind vane
2. Wind vane casing
3. Anemometer
4. Solar power socket
GETTING STARTED
SET UP REMOTE INTEGRATED WIND SENSOR
The Integrated wind sensor takes wind speed and
direction readings.
1. Loosen the screw on the wind vane
2. Install the wind vane on the top of the wind vane
casing with some pressure.
3. Tighten the screw to secure the setup.
BATTERY INSTALLATION
1
2
1. Unscrew the anemometer from the Integrated wind
sensor carefully.
2. Insert batteries matching the polarities (+ / -) and
replace the anemometer. Press RESET after each
battery change.
NOTE
Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.
MOUNTING THE SENSOR
NOTE
The sensor should be positioned in an open area
away from trees or other obstructions.
2
3
4
1
1
2
3
WGR800X_UM_300103595-00005-10_EN_R1.indd 2
To Next Page
Loading...
