Oregon CS250 Original Instruction Manual

28
OREGON® CORDLESS TOOL SYSTEM
CHAIN SAW MODEL CS250
TROUBLESHOOTING
AF 0513  F/N 547361
SYMPTOM POSSIBLE CAUSE RECOMMENDED ACTIONS
Battery pack does
not charge
Battery pack over/under
temperature protection
is activated
This may occur when the saw is run continuously or
exposed to high ambient temperatures. Allow the
battery pack to reach the appropriate temperature
before charging (the overtemp indicator light on
the charger will be on when an over- or under-
temperature condition exists). See “Charging the
Battery Pack” in this manual.
Dirty or damaged
contacts on the battery
pack or charger
Inspect the contacts on the both the battery pack
and charger. If necessary, clean according to the
instructions in this manual. Reinsert battery pack
into the charger, making sure it is fully seated.
Battery pack is at the
end of its life
All batteries have a finite life. If the battery pack
is more than two years old or has been recharged
frequently, it may be time to replace it. Replace
only with the battery specified for the chain saw.
Charger faulty
Take the charger to an approved service location
for a function check.
Low cut time per
battery charge
Dull chain See “Sharpening with PowerSharp®” in this manual.
Worn chain
Replace both the chain and stone. See
“Maintenance and Cleaning” in this manual.
Dry chain
Check the oil level according to the instructions.
Refill oil reservoir if necessary. See “Filling Oil
Reservoir” in this manual.
Improper cutting
technique
See “Basic Cutting” in this manual for proper cutting
technique.
Debris in side cover
Remove battery pack, then remove side cover and
clean out debris.
Battery pack not fully
charged
See “Charging the Battery Pack” in this manual.
Blinking orange
light on charge
state indicator
Possible causes include
charger short circuit,
charger over current,
over voltage limit, open
circuit on battery pack,
or charge/pre-charge
time out error.
Follow these steps:
1. Check to ensure that the plugs into the charger
and the outlet are fully inserted.
2. Make sure the charger is receiving the correct
voltage.
3. If available, try charging a different battery pack
(only packs specified for this charger).
If this does not correct the problem, take the
battery pack and charger to an approved service
location.

Oregon CS250 Specifications

General

Brand	Oregon
Model	CS250
Category	Chainsaw
Language	English