Oregon CS300 - ASSEMBLING THE GUIDE BAR AND SAW CHAIN

15
OREGON® Cordless Tool System
CHAIN SAW MODEL CS300
UNPACKING AND ASSEMBLY
AA 1214 - F/N 573259
UNPACKING AND ASSEMBLY
UNPACKING
DANGER: TO AVOID SERIOUS
PERSONAL INJURY, DO NOT OPERATE
THE CHAIN SAW WITHOUT THE GUIDE
BAR, SAW CHAIN AND SIDE COVER
PROPERLY ASSEMBLED.
WARNING: DO NOT ATTEMPT TO
OPERATE THE CHAIN SAW IF ANY
PART IS DAMAGED OR MISSING.
WHAT’S IN THE BOX?
The chain saw requires some assembly
before use. These items ship with the
chain saw:
• Powerhead
• Guide bar
• Saw chain
• Blade cover
• Chain tensioning gear
• Chain tensioning o-ring
• Chain tensioning screw
• Bar and chain oil
• Charger and power cord (if so equipped)
• Battery (if so equipped)
After removing the chain saw from the
box, inspect it carefully to ensure no
damage has occurred during shipping,
and that no parts are missing. If any parts
are damaged or missing, do not use the
chain saw. Contact OREGON® Cordless
Tool System at .. to obtain
replacement parts.
CHECKING THE FRONT HAND
GUARD POSITION
After unpacking the chain saw, check the
position of the front hand guard. The
chain saw will not run with the chain
brake engaged. Pull the front hand guard
back towards the front handle before
operation (Fig. ).
FRONT HAND GUARD
IN OPERATING POSITION
FRONT HAND GUARD
IN BRAKE POSITION
FIG. 7