Oricom UHF2190 - Activating the Auto Channel Scan; Vibrator and Call alert

17
a. Press the MENU button 4 times, “VOX” icon will be
displayed and “OFF” ashes on the LCD screen.
b. Press the UP button to set the VOX sensitivity into
maximum level (the maximum level is “3 ”.) To deactivate
the VOX function, press the DOWN button until “OF”
appears on the LCD Screen.
c. Press the PTTbuttontoconrmyoursetting.“VOX” will
steadily appear on the LCD Screen as along as the VOX
feature is activated.
VOX operation is not recommended if the radio will be used in a
noisy or windy environment.
Activating the Auto Channel Scan
Channel scan perform searches for active signals in an endless
loop for all 80 channels, 38 CTCSS codes and all 83 DCS codes.
a. Press the MENU button 5 times, “SCAN” icon will display
on LCD screen.
b. Press the UP or DOWN button to begin scanning
channels when an active signal is detected, channel scan
pauses on the active channel.
c. Press the MENU button six times, CTCSS flashes on
the LCD screen press the UP or DOWN button to begin
scanning the CTCSS from 1-38.
d. Press the MENU button seven times, DCS flashes on
the LCD screen. Press the UP or DOWN button to begin
scanning DCS code 1-83.
e. Press the PTTbuttontoconrmyoursetting.
Vibrator and Call alert
Your radio can alert you to incoming signal by emitting an audible
call tone and vibration signal.
Operation
OR011253 UHF2190_2195 User Guide_11-07-14.indd 17 2014/11/7 14:31:11