13
Operations
PTT (Push-To-Talk) button
Pressing the PTT allows audio to be transmitted, by speaking across
the front of the controller speaker microphone.
TX is indicated by the level bars on the LCD display. To receive,
release the PTT button and then TX will disappear on the display.
When transmitting, hold the MIC 5 cm from your mouth and speak
clearly in normal voice across the front of the mic.
Scanning
The Scan feature allows you to search for active
channels automatically.
There are two scanning modes: Open Scan and
Priority Scan. Both of these scan modes can be
set from the menu.
Open scan
Press Scan/Menu button and scanning starts. The OS sub menu
display appears on the LCD.
The scan direction can be changed at any time by rotating the
channel selector left or right.
To stop Scan, press Scan/Menu Button or PTT button.
When a signal is found, scanning will stop at that channel to allow the
signal to be heard, then resume scanning when the channel is clear
again.
CH 1-2-3-4-5-6-7 …… 77-78-79-80
Press
To Next Page
Loading...
Need help?
General
