Oriental motor BLE2 Series - 7. Setting of rotation direction

Operating using external signals
31
7. Setting of rotation direction

Rotation direction of the motor output shaft
The rotation direction of the motor output shaft represents the direction
when viewed from the motor output shaft side.
The motor rotation direction when the FWD input is turned ON can be
changed using the
MEXE02
or operation panel.
The gure shows when the "Motor rotation direction" parameter is set to
“Positive direction=CW.”
CCW
(REV input signal)
CW
(FWD input signal)
Rotation direction of the gearhead output shaft
The rotation direction of the gearhead output shaft varies depending on the type or the gear ratio of the gearhead.
Check the operating manual included with the motor for the rotation direction of the gearhead output shaft.

Rotation direction when the local control operation is performed
During the local control operation, the rotation direction is continuously displayed blinking when the motor is at standstill.
At this time, the motor rotation direction can be changed by pressing key.
In the case of FWD:
(Factory setting)
Local control operation:
Using 3 keys of
,
and
,
the motor can be operated.
In the case of REV: