Oriental motor BLE2 Series - System Configuration

8
System conguration
The system conguration of the
BLE2
Series is shown below.
The gure below shows the driver for the electromagnetic brake motor.
Driver
Motor
(sold separately)
Connection
cable
(sold separately)
• Setting of operation data and
parameters
Sensor
connector
Electromagnetic
brake connector
Motor
connector
External control
equipment
Connects I/O signals.
Power supply
Make sure power
supply voltage does
not exceed the rated
voltage.
Circuit breaker
or earth leakage
breaker
Always connect a
breaker to protect
the primary circuit.
PC in which the support software
MEXE02 has been installed
To connect to the driver, provide a
commercially available USB cable.
The PC must be supplied by the user.
Input
Output
• Setting of operation speed and
torque limiting
(for external analog setting devices)
External poentiometer
(sold separately)
Connect the
potentiometer when
setting the motor speed
or torque limiting value
externally.
External DC voltage
Connect a DC power supply when
setting the motor speed or torque
limiting value by DC voltage.
Or
Regeneration unit RGB100
(sold separately)
Use the regeneration resistor when
continuous regeneration operation
such as gravitational operation in
vertical drive is performed or an
inertia load is operated with round
shaft type motors of 300 W or higher.
⇒
p.19