What to do if my Oriental motor Engine fails to turn on?
If your Oriental motor Engine isn't turning on, ensure that both the START/STOP and RUN/BRAKE inputs are set to the ON position. Additionally, the internal potentiometer might need adjustment; try turning it slightly clockwise, as the speed is set to 0 r/min at the factory.
Why is my Oriental motor Engine running in the wrong direction?
The Oriental motor Engine might be running in the opposite direction due to a few reasons. First, check the CW/CCW input; the motor runs clockwise (CW) when this input is ON and counter-clockwise (CCW) when it's OFF. Ensure the connection isn't faulty. Also, if you're using specific speed reduction ratios (30:1, 50:1, or 100:1 with a combination type parallel shaft gearhead, or 20:1 and 30:1 with a geared type), the drive direction will be opposite; in this case, reverse the CW/CCW input operation.
How to fix an Oriental motor Engine that won't stop immediately?
If your Oriental motor Engine doesn't stop immediately, try stopping the motor by using the RUN/BRAKE input instead of the START/STOP input. It's also possible that the load inertia is too high; try increasing the frictional load or reducing the load inertia. Finally, check the acceleration/deceleration time potentiometer to ensure the deceleration time isn't set too long.
What to do if Oriental motor Engine does not run?
If your Oriental motor Engine isn't running, ensure that the motor (gearhead) output shaft and the load shaft are properly aligned and connected. Also, check for any noise interference by running only the motor, driver, and external potentiometer. If noise is present, take measures such as separating the motor from the noise source, reconnecting the wiring, using a shielded cable, or installing a ferrite core.
General safety guidelines for handling and environment.
Safety measures for installation and electrical connections.
Safety guidelines during motor operation.
Mounting instructions for geared and parallel shaft gearheads.
Mounting instructions for hollow shaft flat gearhead types.
Mounting instructions for the round shaft motor type.
Mounting instructions for the pinion shaft motor type.
Connecting loads to gearhead and round shaft motor types.
Attaching loads to hollow shaft flat gearhead types.
Methods and locations for installing the driver unit.
Wiring examples and static electricity precautions for installation.
Procedure for connecting the motor cable to the driver.
Guidelines for connecting the DC power supply to the driver.
Wiring I/O signals for different motor models.
Explanation of driver I/O circuits and connection examples.
Explains functions of input signals (START/STOP, RUN/BRAKE) and output signals.
General| Brand | Oriental motor |
|---|---|
| Model | BLHD50K |
| Category | Engine |
| Language | English |
To Next Page