Orion 250 HCCA - ORION 425 HCCA; DESCRIPTION; SPECIFICATIONS

FUSEHOLDER
SPEAKER
CONNECTIONS
CABLE ASSY
ORION 425 HCCA
Four Channel
High Current Power Amplifier
100 Watts RMS
EQUIPMENT SUPPLIED
FUSEHOLDER
\
4-CHANNEL
AMPLIFIER
POWER ON LEDS
ASSEMBLIES
A SIDE
GAIN CONTROL'
ASIDE
DIN CONNECTOR
POWER
LEADS
B SIDE/
DIN CONNECTOR
B SIDE
GAIN CONTROL
TURN-ON CONNECTION
WIRE (BLUE)
DESCRIPTION
The 425 HCCA contains two pairs of stereo ampli¬
fiers with a separate power supply for each pair of
amplifiers. It has been designed for installations
where space limitations preclude the use of separate
stereo amplifiers. Each of the four channels supplies
25 watts RMS or 400 watts at 1 ohm when bridged
using ORION Bridging Module 400 BDG (refer to
page 6).
As shown above, two power cable assemblies and
two power leads are provided (one for each of the
internal power supplies). Each pair of amplifiers
must be grounded separately as shown on pages 30
and 31. A single blue turn-on wire is used to turn on
all four channels.
Output Power Per Channel
with all channels driven
into 4 ohms @12 Vdc. 25 WRMS
Distortion:
Typical. 0.005%
Maximum.0.03%
SPECIFICATIONS
I Input Impedance
MOUNTING
HARDWARE
TWO 30 AMP
FUSES
10K ohms
Remote Turn-on Current.50 mA
Current Consumption:
@ No Signal.
@ Maximum Output
. 500 mA
70 Amps
Frequency Response.6 Hz to 50 KHz ±0.5 dB Voltage Requirements.10V to 16V
Signal to Noise Ratio. 112 dB
Input Sensitivity.150 mV to 2 Vrms
Damping Factor.Greater than 500
Output Section Slew Rate
30V per microsecond
Output Impedance.0.5 ohm to 16 ohms Stereo Separation
Overall Dimensions. 22 x 8.5 x 2.25 inches