Need help?Do you have a question about the Orion Cobalt CO300.2 and is the answer not in the manual?
Lists the components included with the amplifier package.
Provides safety guidelines regarding high sound pressure levels and hearing protection.
Indicator that shows the amplifier's operational status.
Connects speaker outputs from the head unit to the amplifier.
Accepts RCA input from source units, preamplifiers, or equalizers.
Adjusts input sensitivity for optimal power output.
Selects between Hi-pass, Full range, or Lo-pass crossover.
Adjusts the frequency of the low-pass crossover.
Adjusts the frequency of the high-pass crossover.
Adjusts bass gain in three steps (0dB, 6dB, 12dB).
Indicates fault conditions and muting phase during turn-on.
Terminals for connecting speakers, accepting up to 12 AWG wire.
Specifies the fuse type and rating for amplifier protection.
Terminals for power cables, accepting up to 4 AWG wire.
Input for remote turn-on signal from the source unit.
Terminal for connecting the amplifier's ground cable.
Detailed CEA-2006 compliant power and noise ratio specifications for the CO300.2 model.
Detailed CEA-2006 compliant power and noise ratio specifications for the CO600.2 model.
Table detailing wire color and corresponding input connection for high-level signals.
Overview of input section features including phase switch, gain, and RCA inputs.
Instructions on adjusting input sensitivity for system integration.
Details on the amplifier's continuously variable crossover section.
Explanation of the low-pass crossover's slope and frequency range.
Explanation of the high-pass crossover's activation and frequency range.
Guidelines for connecting the amplifier's power supply and fuses.
Diagrams illustrating speaker connections for stereo and bridged modes.
Instructions for wiring speakers in tri-mode configuration.
Guidance on bridging channels for single speaker loads.
Factors to consider when selecting a location for amplifier mounting.
Considerations for mounting the amplifier in the passenger cabin.
Considerations for mounting the amplifier in the trunk.
Important safety warnings and tips for a proper installation.
A sequential guide for installing the amplifier.
Steps to verify the system installation and operation after setup.
Procedure for fine-tuning audio levels and crossovers for optimal sound.
Diagnosing and resolving problems related to lack of audio output.
Troubleshooting intermittent audio output or power cycling.
Identifying causes and solutions for distorted audio playback.
Resolving issues related to weak or inaccurate bass frequencies.
Diagnosing and fixing problems causing the main battery fuse to blow.
Troubleshooting causes for the amplifier's internal fuse blowing.
Technical specifications for the amplifier's power, distortion, and input characteristics.
Specifications for the amplifier's low pass and high pass crossover features.
Details of the extended warranty for units purchased and installed by authorized dealers.
Terms of the standard warranty for units purchased without authorized dealer installation.
Conditions under which the warranty may be voided or specific damages excluded.
Legal disclaimers, state-specific rights, and limitations of liability.
To Next Page
General
