Need help?Do you have a question about the Orion HCCA 225G4 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Signal to Noise Ratio | >100 dB |
| Input Sensitivity | 200mV - 6V |
| Crossover Frequency | 50 Hz - 250 Hz |
| Bass Boost Frequency | 45Hz |
| Phase Shift | 0-180 degrees |
| Bass Boost | 0 to +18 dB |
| Fuse Rating | 30A |
| Subsonic Filter | 50 Hz |
Outlines warranty periods for parts and labor based on purchase and installation.
Lists conditions and situations not covered by the amplifier's warranty.
Details amplifier power output across various impedances and channels.
Highlights crossover flexibility and subwoofer optimization features.
Explains the operation and variable frequency range of the low-pass crossover.
Describes bypassing and configuring the high-pass crossover for different uses.
Recommends INTELLI Q boost levels based on enclosure type for optimal performance.
Covers initial steps like locating the amp, planning configuration, and running wires.
Details pre-drilling, mounting, and connecting RCA, speaker, and power wires.
Guides on final connections, battery reconnection, configuration, and fuse installation.
Addresses causes and solutions for amplifiers experiencing no output.
Provides fixes for amplifiers that cycle on and off due to thermal protection or loose connections.
Solves distorted output issues by adjusting gain and checking impedance load.
Diagnoses fuse blowing issues related to incorrect fuse size or excessive current draw.
Discusses common sources of noise in car audio systems.
Outlines a systematic 1-2-3 method for troubleshooting audio systems.
To Next Page
