Orion OLS-8410NL - Graphic Card Configuration

-44- -45-

Display input selection
• The input mode of the display unit should be configured as described below.
• If the cable connection was made with the input group 1 (HDMI1A, HDMI1B, HDMI1C, HDMI1D), then
press
“
Group 1-UHD
”
button in the remote controller. Press
“
Group 2-UHD
”
button for the input group 2
(HDMI2A, HDMI2B, HDMI2C, HDMI2D).

Graphic card conguration
• Compose one full screen image with 4 separate screens with the graphic configuration software
provided by the graphic card makers.
• Please refer to the user guide of each graphic card maker or contact to the company for detailed usage of the graphic card.
• The configuration for the optional ORION PC is as follows.
• As you connect the output ports of the PC to the input ports in the display, you will see the following
screen. However, the screen image may be different due to various cable connection or PC settings.
• In case you do not have the same screen image like following screen image, you still configure the display as described below.
• Click the right button of your mouse on the desktop to pop up the menu and select
“
Catalyst Control
Center
”
(CCC).