WARNING
WARNING
-6- -7-
- When you install product, make sure there is at least 20cm clearance for effective
ventilation and do not seal off MLCD sets.
If MLCD sets are installed at the locations of bad ventilation, the inner temperature
can be raised rapidly and it can cause frequent malfunctions and rapid reduction of
the product life.
※
Ventilation space in front of product must be furnished for heat dispersion.If the front
space of MLCD has to be sealed, there must be consideration for the heat dispersion in
the rear side of MLCD.
- Carefully install product not to cover the fan air holes with any structural object.
If the holes are covered with anything, the inner temperature can be raised rapidly
and it can cause malfunctions.
- Regularly clean off the vent holes in the back of product sets.
If the vent holes and the fan air holes are clogged with dust, it prevents the air ow
inside of product sets.
It can cause rapid increase of the inner temperature and may cause malfunctions.
Clean off the vent holes and the fan air holes with a vacuum cleaner regularly.
▶
Clearance for Ventilation
▶
Do not cover the vent hole for the fan
▶
Cleaning and Maintenance
Installation structure
Vacuum Cleaner
PWR SRC MODE
AC INPUT ON/OFF
HDMI1A HDMI2A HDMI1B HDMI2B HDMI1C HDMI2C HDMI1D HDMI2D RS232 LAN A/S IR
ENT IR
FAN
To Next Page
Loading...
