8
Electric Balancer Pre-
TO AVOID INJURY, THIS PRODUCT MUST BE PROPERLY ASSEMBLED
BEFORE USE. WE STRONGLY RECOMMEND THAT YOU REVIEW THE
COMPLETE ASSEMBLY GUIDE AND PERFORM CHECKS SPECIFIED IN
THE OWNER’S MANUAL BEFORE RIDING.
Just a minute spent before each ride can significantly improve your safety
and the enjoyment of your ride. EACH TIME before you ride make a habit
of performing the following safety checks:
•
Stand in front of the bicycle facing rearward and hold the front wheel
securely between your legs. Try to twist the handlebar and verify that they
do not move. Then pull the handlebars up, trying to lift the bike. There
should be no movement.
•
Try to push the front wheel from side to side and confirm that it feels
tight and will not wobble. Lift the front wheel up by the handlebars and
strike the wheel downward with the heel of your hand to confirm that it is
securely attached to the wheel. Spin the front wheel and confirm that it
does not wobble or contact the fork or brake pads.
•
Try to lift/push down on and twist the seat to confirm it is tight.
•
Look at the connection of the pedals to the crank arm. You should not
see pedal screw threads and the pedal should feel firm and be parallel to
the ground.
•
Apply your brake(s) and make sure they feel firm to the touch, and then
spin the wheel(s). Apply the brakes. The brakes should stop the wheel(s).
•
Check to be sure that the fenders and accessories (if equipped) are
firmly attached and will not contact any moving parts. Make sure all
reflectors are in position and not broken.
Now, put on your BICYCLE SAFETY HELMET and enjoy your ride. Your
safety is well worth just a minute. Also, be sure to read and follow the
warnings and instructions in this manual
To Next Page
Loading...