27
Repair and Maintenance
BATTERY REMOVAL
Step one: Remove the cover (see page 21)
Step two: After you have removed the cover, take some pictures.
Carefully pull out the wires of the controllers and only unplug the three
pin throttle wires (org, green, blk), 2 pin power switch (pink and black),
2 pin Brake switch (blue, black), yellow XR60 connector for battery. Do
not disconnect the large black round plug or the wires that are zip tied
together. Pull out the controller and let it hang off to the side (pic
below). If you accidentally unplug the large round black connector, make
sure you line up the arrows when you plug it back in together.
To Next Page
Loading...