38
Controller Diagram
FUNCTION WIRE COLOR WIRE VOLTAGE REFERENCE
Connect to Battery
Red 24V
Black Negative
Connect to Motor
Yellow 1.5MM
When motor running, 12v. Stop 0v
Green 1.5MM
Blue 1.5MM
Orange 0.3MM 5v with Power ON
Yellow 0.3MM
When motor running, 12v. Stop 0v
Green 0.3MM
Blue 0.3MM
White 0.3MM
Exchange from 0 to 5v when
running
Black 0.3MM Negative
Connect to Power Switch
Pink 24v
Red
Will have 24v when PWR SW
is ON
Connect to Throttle
Black Negative
Orange 4.3v
Green
Will have 0.8v when at 0 throttle
position and go to 3.5v at full
throttle
Connect to Mode Switch.
White 3p connector
Black and White 5v when not switched to GND
Black Negative
Blue and White 5v when not switched to GND
Connect to Brake Cut-Off
Black Negative
Blue
Has 5v without a brake. Goes to 0v
when brake
Connect together for KSM, kick
start. Red 2p connector
Black Negative
Light Blue
Has 5v when not connected to
GND
Connect together for 50% power.
Black Connector
Black Negative
White
Has 5v when not connected to
GND
Connect together for 20% reduce
torque
Black Negative
Yellow/Green
Has 5v when not connected to
GND
Connect to Beeper
(removed)
Black Negative
Black and Red 5v
To Next Page
Loading...