Orion SC148 - 23 Advanced > HDD Manage

SURVEILLANCE SYSTEM
17
FOUR CHANNEL DIGITAL VIDEO RECORDER SC148
21 SYSTEM > TOUR
The tour menu allows the configuration of the tour function.
The tour function cycles the view modes on the live monitoring
screen automatically.
› ENABLE TOUR: Enable the touring function. The DVR will
display the channels by cycling through all the enabled
channels.
› INTERVAL: This determines the duration the display dwells
on current view channels (5-120 seconds).
› VIEW: Select the channels to be included in the tour display.
› ALARM TOUR TYPE: Alarm Tour is used in conjunction with
the alarm function. When the alarm is triggered, the DVR will
display a single view of the channel that triggered the alarm.
› INTERVAL: This determines the duration the display dwells
on the alarm-triggered channel.
› RETURN AFTER FINISHED: Check box to resume normal
touring after the alarm tour interval expires.
When the tour function is enabled, the following icon will be
displayed on the main monitoring screen. Press the icon to
toggle on and off the tour function.
22 SYSTEM > CHANNEL TYPE
Channel Type allows you to set the resolution of all channels.
It is recommended to select the first setting, which enables the
DVR to operate at the highest recording resolution for all channels.
23 ADVANCED > HDD MANAGE
HDD Manage allows the management of the internal DVR hard
drive storage space.
The table displays the hard drive type, maximum capacity,
remaining storage space and status. Note that externally
connected storage devices like USB flash drives and external
hard drives are not displayed here.
› HDD No.: Number allocated to the hard drive.
› TYPE: Hard drive operating mode.
> READ: Reading hard drive is allowed. Writing to the hard
drive is restricted.
> READ/WRITE: Reading and writing to the hard drive are
allowed.
> REDUNDANT: Backup recording files are stored in this
hard drive.
› STATUS: Status of the hard drive.
> NORMAL: Hard drive is operating normally.
> ERROR: Hard drive is faulty.
> FREE: Hard drive is not in use.
> IN USE: DVR currently recording into the hard drive.
› DISK SPACE: Maximum hard drive storage space.
› READ/WRITE: Set hard drive to read/write.
› READ: Set hard drive to read only.
› REDUNDANT: Set hard drive to store redundant recording
files.
› FORMAT DISK: Remove all data from hard drive. If a new
hard drive is installed in the DVR, select the new drive and
click Format Disk to enable hard drive usage.
› RECOVER: Resume normal hard drive operation.
› PARTITION: Set hard drive partition between video files
and image files.