Operator’s Compartment
Page 7
16. Headlight Dimmer Foot
Control Switch
This foot switch, when
activated, selects the headlight
high or low beam settings.
17. Side Control Panel
This panel, located on the left
hand side of the operator,
contains controls and switches
necessary for various vehicle
systems operations.
These systems include climate
control, front and rear door
control, master control of the
vehicle electrical system,
lighting, etc. See “Driver’s
Side Control Panel” on
page 19.
18. Alternating Current Traction
Motor (ACTM) Gear Selector
Drive modes available on this
selector are Drive (D), Neutral
(N), and Reverse (R).
See
“Gear Range Selector
Position” on page 43.
19. Door Emergency Release
Valve
This rotary air valve overrides
the air system to allow front
doors to be opened manually.
See “Malfunction in Opening
and Closing Front Door” on
page 57.
20. Driver’s Door Control Push
Buttons
The rear and front door
controller push buttons allow
the operator to activate the
front and/or rear doors. Press
once to open and press again
to close the doors.
21. Tilt/Telescopic Steering
Column Lever
The steering column is
equipped with adjustment
features that accommodate the
size and height of most
operators. Tilt and height
features are adjusted using a
lever on the left hand side of
the steering column.
To adjust the tilt angle:
a. Pull back on the lever.
b. Grasp the steering wheel
and adjust the angle forward
and aft until the desired
angle is reached.
Stop the vehicle and apply the
parking brake before adjusting
the steering column. Failure to
do so could result in loss of
vehicle control, causing personal
injury and/or vehicle damage.
To Next Page
Loading...