ORKA EH-PTC - Operating the Heater; Heater Preparation and Time Setting; General Operation Modes

4
OPERATION INSTRUCTION
1. Before inserng the plug into an electrical outlet, make sure that the
electrical supply in your area matches that on the rang label on the unit.
2. Carefully remove the heater from the plasc bag and the carton.
3. Place the heater on a rm, at, level surface, seng the master buon to
“-”posion, plug the cord set into a AC220-240V~ electrical outlet. There
will be a “BEEP” sound and the “Powerlight is on and the heater display will
show the default temperature, it will blink for 5 seconds.
1) HEATING PERPARE
Set me
Before turn on the heater,set the me as right me.Press remote control “ ”
buon, light on control panel,LED display shows 00:00 and “Mo”light on.
HOUR Press “Set” buon one me,LED display front “00” ashes, press “
two buons set the Hours from 01--00(01=1 o’clock,02=2 o’clock...00=24
o’clock ect.)
MINUTE Press “Set” buon again,LED display behind “00” ashes, press “
two buons set the minutes from 00--59(01=1 Minute,02=2 Minute ect.)
WEEK Press “Set” buon again,“Mo”light ashes ,press “ two buons set
the week from Mo--Su (Mo=Monday...Su=Sunday ect.)
PS: Press “Set” buon, screen shows number will ashes 5 seconds, you should
operate in me, otherwise appliance will get back to standby.
(Appliance will keep the right me unl power o)
2) General Using OPERATION
1. Turn the heater ON by pressing the ON/OFF main buon ,the unit will
blow the cold air and “ ” light is on.
2. Pressing the “MODE” buon ,the unit will blow the warm air and both“ ”
and “ ” lights are on.
3. Pressing the “MODE” buon second mes,the unit will blow the hot air and
both “”“” lights are on.
4. Pressing the “MODE” buon Three mes,the unit will blow the cold air and
“Fan/M” light is on.
PS: On control panel “ ” buon, press 1st me is COOL AIR; 2nd mes is
WARM AIR; 3rd mes is HOT AIR; 4th mers is SWING FUNCTION; 5th mes
is OFF,pls noted it.