INSTALLATION MANUAL OPERATION MANUAL
KANNAD 406 AS
PAGE 202
JUN 29/2022
© 2022 Orolia S.A.S. All rights are strictly reserved.
A. Pin programming option
The KANNAD 406 AS offers pin-programming capabilities to facilitate
maintenance operations especially in the case of removals and/or
replacement.
A special DIN 12 connector with a Serial Memory Module (called “Programming
Dongle”) is connected to the ELT when installed on board (optional). This
Programming Dongle contains the identification information of the aircraft and
remains on board the aircraft. When an unprogrammed ELT is installed and
connected to this Programming Dongle and the “ELT” is switched to “ARM”, it
automatically updates its own memory with the identification data contained in
the Programming Dongle memory.
When the ELT is removed from the aircraft, it keeps its identification data.
For maintenance purposes, it is possible to delete the identification information
of the ELT by connecting a “Maintenance Dongle” to the ELT. Any accidental
transmission with this “maintenance dongle” will not involve SAR operation as
the identification code transmitted is recognized by COSPAS-SARSAT as “not
on board”.
When a maintenance dongle is connected:
• Country code is 227 (France).
• Protocol is Test.
• Identification number is SI + 5 digits (the last 5 digits of CSN number) or
K + 6 digits (the 6 digits of the CSN number).
If the pin programming option is selected by the operator, the following
equipment are required:
• a “Programming Dongle” on each aircraft;
• a “Maintenance Dongle” on each ELT spare.
Figure 201: Maintenance Dongle
To Next Page
Loading...
