INSTALLATION MANUAL OPERATION MANUAL
KANNAD 406 AS
PAGE 203
JUN 29/2022
© 2022 Orolia S.A.S. All rights are strictly reserved.
2. Installation
“The location of the ELT shall be chosen to minimise the potential for
inadvertent activation, damage by impact, fire and contact by passengers or
baggage” (RTCA DO-183)
“The ELT must be attached to the aircraft in such a manner that the probability
of damage to the transmitter in the event of a crash impact is minimised.” (FAR
91.207)
The ELT shall not be installed less than 60 cm (2 ft) from a magnetic field
sensor.
The KANNAD 406 AS can be either packed in a carry off bag or installed on a
mounting bracket.
A. Installation with Carry-Off Bag
The KANNAD 406 AS is packed in a carry off bag with 3 handles for easy
handling.
(1) Packing instructions
• Check that the switch is in the “OFF” position (“ARM” if the beacon is fitted
with a water switch sensor).
• Slide the antenna though the hole provided in floating collar.
• Put the ELT with the antenna downwards so that it fits on lower part of the
wedging foam.
• Turn it ¼ turn so that the antenna fits between top and bottom wedging
foam.
• The ELT should wedge into place.
Figure 202: Packing Instructions
To Next Page
Loading...
