PAGE: 104
MAR 30/2020
INSTALLATION MANUAL OPERATION MANUAL
KANNAD 406 AF / AF-H / AF (6D)
© 2020 Orolia S.A.S. All rigths are strictly reserved.
aircraft is parked for a long period or for maintenance.
The Remote Control Panel is energized by the ELT when the ELT’s Switch is
in the "ARM" position.
D. On
This mode is selected
:
•
manually by switching to position "ON";
• by switching the Remote Control Panel switch to "ON" (provided that t
he
ELT s
witch is in the "ARM" position);
• when a crash occurs (provided that the ELT switch is in position "ARM").
When this mode is selected, the ELT starts transmission:
• on 121.5 MHz & 243 MHz immediately (continuous transmission);
• on 406 MHz after approximately 50 seconds (406 MHz burst
every 50 sec
dur
ing 24 hours).
The red visual indicator on the ELT (and on the remote control panel if installed)
flashes and the buzzer operates.
In case of accidental activation, the ELT can be reset either by switching it to
"OFF" or by switching to "RESET" on the Remote Control Panel.
The number of 406 MHz bursts effectively transmitted is recorded. This
information is available when the ELT is connected to a programming and test
equipment (PR600).
To Next Page
Loading...
