31
Sentry Ramp-Hold Shorthand Instructions
After you press the keys in the left column, the message to the right will appear.
KEYS TO PRESS DISPLAY COMMENTS
PROGRAM AND FIRE THE KILN.
Apply power to kiln IdLE Press Enter if IdLE does not appear.
4 USER Enter program number.
1, 2, 3, or 4 1 Program number appears.
ENTER RA 1 Enter rate of segment 1.
Rate 0200 Rate appears.
ENTER °F 1 Enter temperature of segment 1.
Temperature 2000 Temperature appears.
ENTER Hd 1 Next, enter hold time.
Hold time (0 if none) 00.00 Hold time appears.
Repeat for other segments. Enter rate of 0 for 1st segment not needed.
ENTER IdLE The kiln is ready to fire.
ENTER STRT Kiln is now firing.
SELECT AND FIRE A STORED USER PROGRAM.
Apply power to kiln IdLE Press Enter if IdLE does not appear.
4 USEr Select a program number.
1, 2, 3, or 4 1 Displays the number you selected.
ENTER RA 1
STOP IdLE Selected program is ready to fire.
ENTER STRT
Kiln is now firing. (Use Program Review by pressing 6.)
Appendix E:
To Next Page
Loading...