53 GB
adVanced inSTRucTiOnS fOR uSe
meaSuRing The SlOpe angle/paRTneR checK
MEASURING THE
SLOPE ANGLE
Open S1+, use the “MENU” button
to select the “Slope measurement”
function via “Settings”.
Place top side of the S1+ exactly flush
with the snow surface. Tolerance of
accuracy of the slope sensor: +-1°.
The determined measurement can be
kept by pressing the „OK“ button (2).
A new measurement can be taken by
pressing the “OK” button (2) again
PARTNER-CHECK
The PARTNER CHECK with limited
range should be carried out every
day before starting a tour!
The PARTNER CHECK function is
used to check the frequency (457
kHz), the width of the transmitting
signal and the cycle duration that the
transmitting signal.
To Next Page
Loading...
