ZOOM+
EN
INSTRUCTIONS
•Switch the ZOOM+ to locating.
Push the two sliding switches ()
outward simultaneously.
•If the partner device is transmitting,
the screen will display the distance
(e.g. “.”) from the transmitter.
•Only one transmission signal can ever
be tested at a time. The minimum distance
during the partner check is m;
the distance to other transmitters
must be at least m.
•If there are no transmitters within the
reception area of the ZOOM+, the dynamic
“signal search” symbol (“S”) appears on
the screen.
OX-GAL-ZOOM+-BUCH-vh.indd 35 06.06.13 15:48
To Next Page
Loading...
