EN
ZOOM+ INSTRUCTIONS
SWITCHING ON
Turn the ON/OFF switch () clockwise.
The rotary switch clicks into the position
“ON” and is now secured against being
unintentionally switched o.
SWITCHING OFF
Press in the ON-OFF switch () to unlock
it then turn it counter-clockwise to the
“OFF” position.
After switching on the ZOOM+,
the -digit serial number appears.
The automatic self-test begins
with the display check.
The transmitter, receiver, smart antenna,
and sensors are then tested.
The remaining battery capacity is also
displayed as a percentage (e.g. “”).
For further information about the battery, see p.
The installed software version then follows (e.g. “.”)
INITIAL USE
SELF-TEST, TRANSMISSION MODE (device in transmission mode)
OX-GAL-ZOOM+-BUCH-vh.indd 32 06.06.13 15:48
To Next Page
Loading...
Need help?
General
