To Next PageTo Next Page
Need help?Do you have a question about the Oru Kayak HAVEN and is the answer not in the manual?
General| Category | Kayak |
|---|---|
| Material | Polypropylene |
| Width | 31 in (79 cm) |
| Assembly Time | 5 minutes |
| Max Paddler Height | 6 feet 6 inches (198 cm) |
Hold the reinforcing rod securely in place.
Ensure proper installation of floorboards in the boat.
Connect to the seat column holding the seat system.
Allow easy setup of multiple seating configurations.
Reinforces kayak bottom and holds the front seat.
Reinforces kayak bottom and holds rear/middle seat.
Used to carry the kayak when in box form.
Attached to the front half for tandem/single configurations.
Attach floorboards to skin and mount accessories.
Hold the two bulkheads securely in the inner hull.
Includes seat column and adjustable backrest.
Includes seat column, backrest, and footrest for rear paddler.
Provides structural rigidity to the kayak.
Tuck under the bungee in the floorboard.
Adds additional rigidity to the kayak.
Contains extra hardware for repairs and upkeep.
Unpack the kayak components from the shipping box.
Unfold the kayak skin from its compact box form.
Secure the front section of the kayak using buckles and straps.
Secure the rear section of the kayak using buckles and straps.
Insert and secure the floorboards into the kayak hull.
Install the front seat, footrest, and reinforcing rod for tandem use.
Install the rear seat and footrest for tandem use.
Install the seat and footrest for single paddler use.
Loosen, slide, and re-tighten the backrest for optimal height.
Fine-tune seatback straps and footrest for comfort.
Detach components, loosen buckles, and pull fairings to prepare for folding.
Fold the kayak in sections and twist to form the original box shape.
Place all parts into the box and secure with closure straps.
