6
Overview
The SCA 3600 Support Cleaning Apparatus (SCA) is designed to remove soluble support
from FDM parts (PLA, ABS, PC, nylon) and Material Jetting (MJ) parts (UV Cured Resins)
using water or approved caustic cleaning solutions.
How it works
The SCA removes support material by immersing parts created with soluble support
material in a bath consisting of water or cleaning solution. The SCA is designed to
accommodate a broad range of material specific cleaning solutions and bath
temperatures. The gentle bath agitation dissolves the support material without harming
the underlying model material. The time required to remove the support material
depends on model geometry and the total amount of support material. When the
soluble support material is completely removed, models are unloaded from the SCA,
rinsed, dried, and ready for further finishing or use.
To Next Page
Loading...