OSAKA – SMART BOX – Simple Manual – v1.1 – Page 16
13.2 Additional information for the electric connection_______________________________ ______________________
Do not operate with the device’s terminal block using electric screwdrivers or pneumatics.
If the device has been moved from a cold place to a hot one, the humidity can condense in its interior; wait for approximately an
hour before connecting it to the power supply.
Make sure that the power’s supply voltage, and the device’s electric frequency and the power are proper with the local power
supply; consult the TECHNICAL DATA chapter of the extensive manual.
Connect the device to the MODBUS RS-485 network by using a twisted wire.
Place the supply cables as far as possible from the signaling cables.
14 – WARRANTY AND REPAIR R
The controller has a repairing or replacement warranty due to manufacturing defects of 12 months from the purchasing date.
OSAKA SOLUTIONS will automatically cancel aforementioned warranty and will not be held accountable for possible damages that
result from:
- The use, installation, usage or improper handling that differs from the one previously stated, and specially if it differs from the
safety prescriptions established by the law.
-The use in applications, machines or frames that do not guarantee an adequate protection against liquids, dust, grease and
electric shocks in the performed mounting conditions.
-The inexpert handling and/or the modification of the product.
-The installation/use in application, machines or frames that do not comply with the current regulations set by the law.
In case of having a defective product under warranty time or out of warranty time, it is necessary to contact the post-sales service
to perform the appropriate procedures. Request the “RMA” reparation document (by email or fax) and fill it, it is necessary to send
the RMA and the controller to the SAT OSAKA (Technical Assistance Service) by prepaid freight.
To Previous Page
Loading...
