- 21 -
Isox connectors
• Insert the black insertion aids through the slit in the
cushion between the back rest and seating area
and into the Isox holders.
• Ensure that the at side is pointing downwards.
This is not necessary if the vehicle already has
rmly installed insertion aids.
• Press both side buttons on the
Isox connectors to
extend them in length.
• Insert the Isox connectors into the insertion
guides and press until you hear a click.
• The display on both sides only turns green when
the connections have been established. Slide the
child car seat towards the backrest until it stands
securely.
Additional fastening with
Top tether
(Group 0+/1, rearward facing)
• Remove the Top-Tether from the bag.
• To release the top tether, press the grey button
with one hand and pull the side of the belt anchor
to the required length with the other hand.
• In order to ax the Top-Tether, hang the anchor to
the xation point on the car seat and pull it as tight
as possible. The display does not turn green until
the belt is locked.
EN
To Next Page
Loading...
Need help?
General
