OSD Audio SMPS500DSP User Manual

SMP500DSP
|
hie
Free
EEAUDIO
OWNERS MANUAL
Specifications
WARNING
TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
. THIS APPLIANCE SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING WATER AND THAT NO
Total H . oe TTED as (RMS @ 4Q) 1000Watts (Peak @ 40) OBJECT FILLIED WITH LIQUIDS SUCH AS VASES SHALL BE PLACED ON APPARATUS.
Otal Harmonic Vistortion : <1%
Equalizer: Adjustable Built-in 7 -Band
(-24dB to +128) CAUTION
Adjustable Low Pass Crossover: 20Hz to 150Hz/ 0.5 Hz Increments
Adjustable Slope: 12 dB-48dB
Line Level Input Sensitivity: 190 mV
Phase Control: 0 to 315° / 45° Increments
Auto Turn-on Sensitivity: 3 mV @ 50 Hz
Extrenal Trigger: 12V
Thermal Protection Circuit: Yes
Night Mode: Yes
Remote Control: Yes
Single Ended and Balance Input: Yes
Dimensions (with rack mounts): 17.13” W (435mm)
1.75” H (45mm)
9.45 "D (240mm)
7.6 lbs (3 46kg)
6.3 Amp (120V)
3.15 Amp (240V)
This symbol is intended to alert the user to the presence of
uninsulated “dangerous voltage” with in the product’s enclosure that
may be of sufficient magnitude to constitute risk of electric shock to
persons.
This symbol is intended to alert the user to the presence of
important operation and maintenance (servicing in the literature
accompanying the appliance.
Weight:
Fuse:
Ue ee)
Electricity is used to perform many useful functions, but it can also cause personal injuries and
property damage if improperly handled. This product has been engineered and manufactured
with the highest priority on safety. However, improper use can result in electric shock and / or
fire. In order to prevent potential danger, please observe the following instructions when
installing, operating and cleaning the product. To ensure your safety and prolong the service
life of your Sound Bar, please read the following precautions carefully before using the product.
Trouble Shooting
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat.
The battery shall not be exposed to excessive heat such as sunshine, fire
or the like.10. Do not defeat the safety purpose of the polarized or grounding-type plug.
Apolarized plug has two blades with one wider than the other. A grounding type
plug has two blades and a third grounding prong. The wide blade and the third
prong are provided for your safety. If the provided plug does not fit into your
outlet, consult an electrician for replacement of the obsolete outlet.
11. Protect the power cord from being walked on or pinched particularly at the plugs,
convenience receptacles, and the point where they exit from the apparatus.
1 . Verify that all wires are properly con nected . 12. Only use attachments/accessories specified by the manufacturer.
. . 13. Use only with the cart, stand, tripod, bracket, or table specified by the
2 . Verify that all con nections are Com plete manufacturer, or sold with the apparatus. When a cart is used, use
. : . caution when moving the cart/apparatus combination to avoid injury
and secure, with no stray wires contacting
other terminals.
from tip-over.
8. Check each individual subwoofer
SYMPTOM POSSIBLE CAUSE AND TEST PROCEDURE
1. Check that the amplifier is plugged into an A/C power
outlet and has power.
Negponynn
2. Make sure that the subwoofer(s) is/are connected
properly. 0.
3. Make sure there is an audio signal from pre-amp /
No sound from
the subwoofer‘(s).
receiver.
Sound from at least
one subwoofer, but
not the other(s).
14. Unplug this apparatus during lightening storms or when unused for long periods
of time.
15. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or
has been dropped.
16. The mains plug or an appliance coupler is used as a disconnect device, the
disconnecting device shall remain ready operable.
Warranty
All OSD AUDIO electronics have (2) year Limited Warranty against defects in materials and workmanship. Proof of purchase must accompany all claims. During the warranty
period OSD AUDIO will replace any defective part and correct any defect in workmanship without charge for either parts or labor
OSD AUDIO may replace returned electronics with a product of equal value and performance. In such cases, some modifications to the mounting may be
necessary and are not OSD AUDIO’s responsibility.
For this warranty to apply, the unit must be installed and used according to its written instructions. If necessary, repairs must be performed by OSD AUDIO. The unit must be
returned to OSD AUDIO at the owner’s expense and with prior written permission. Accidental damage and shipping damage are not considered defects, nor is damaged resulting
from abuse or from servicing performed by an agency or person not specifically authorized in writing by OSD Audio
OSD AUDIO sells products only through authorized dealers and distributors to ensure that customers obtain proper support and service. Any OSD AUDIO product purchased
from an unauthorized dealer or other source, including retailers, mail order dealers and online sellers will not be honored or serviced under existing OSD AUDIO warranty policy.
Any sale of product by an unauthorized source or other manner not authorized by OSD AUDIO shall void the warranty on the applicable product.
Damage to or destruction of components due to application of excessive power voids the warranty on those parts. In these cases, repairs will be made on the basis of the retail
value of the parts and labor. To return for repairs, you must email customer service at RMA@audiogeargroup.com for a Returned Merchandise Authorization (RMA) number then
the unit must be shipped to OSD AUDIO at the owner’s expense, along with a note explaining the nature of service required. Be sure to pack the product(s) in a corrugated
container with at least 3 inches of resilient material to protect the unit from damage in transit.
This Warranty Does Not Cover: Damage caused by abuse, accident, misuse, negligence, or improper operation (installation) * Any products that have been altered or modified «
Any product whose identifying number of decal, serial #, etc. has been altered, defaced or removed * Normal wear and maintenance.
OSD AUDIO | Brea, CA | osdaudio.com
SMP500DSP
Manual
revi
4/18

OSD Audio SMPS500DSP Specifications

General

Brand	OSD Audio
Model	SMPS500DSP
Category	Amplifier
Language	English