EasyManua.ls Logo

Oster BVSTEM3300 - Description of the Appliance; Caution: Pressure

Oster BVSTEM3300
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English-3 English-4
DESCRIPTION OF THE APPLIANCE
Control Knob
Steam
OFF
Brew
6
7
9
8
10
3
4
2
5
1
1. Water tank cap
2. Dial control knob
3. Indicator light
4. Steam wand
5. Removable wand cover
6. Removable drip tray
7. Reusable coffee filter basket
8. Glass carafe with spill-proof lid
allows you to prepare up to 4
shots with a single brew
9. Extra-large portafilter
10. Coffee measuring scoop/
tamper
CAUTION: PRESSURE
In order to check if the appliance is under pressure, follow these steps:
1. Turn the control knob to the off position and unplug the appliance.
2. Rotate the control knob to the steam position . If steam comes out of the steam
wand, then the water tank is still under pressure. Turn the control knob to the off
position .
3. To release the pressure, hold a pitcher with water under the steam wand and immerse
it in the water. SLOWLY TURN THE CONTROL KNOB TO THE STEAM POSITION
AND RELEASE THE STEAM.
4. When the steam wand stops releasing steam, turn to the off position and slowly
remove the cap.
5. Do not remove the portafilter at any time during the brewing process or until pressure
is relieved.
6. Use caution when removing the portafilter. The metal parts may still be very hot. Also,
there may be hot water floating on the top of the filter.
7. If coffee does not drip from the portafilter, it could mean it is blocked. Allow the
appliance to cool down, and then release the steam with the instructions above.
The blockage may be caused by too finely ground coffee. See “PROBLEMS AND
CAUSES” section.
8. WHEN CLEANING THE STEAM WAND: Place a frothing pitcher or large cup with at
least 325 mL (11 oz.) capacity half full of water under the steam wand. Make sure the
tip of the steam wand is submerged in liquid before turning the control knob to the
steam position. Froth the water for approximately 15 seconds.
NOTE: In order for your unit to work properly time after time, clean the steam wand
after each use.
WARNING: The filling aperture must not be opened during use.
BVSTEM3300-013_23SEM1 (LA).indd 3-4BVSTEM3300-013_23SEM1 (LA).indd 3-4 2023/6/21 09:242023/6/21 09:24

Related product manuals