Oster GCSTCC5000 - Ironing Pants; Troubleshooting

English - 12
IRONING PANTS
• Begin with the waistband and inseam area, then pockets and cuffs.
• Pull waistband on pointy end of the board, as if you’re “dressing” the ironing board. Iron
upper-front part of the pants, including the waistband.
• Place pants parallel to ironing board lengthwise so both legs are facing the same
direction. Iron each leg by moving the iron back and forth along the pant leg.
• Take cuff of the leg and bring it over towards the waistband to iron the inner part of the
leg. Repeat these 2 steps for the second leg.
Troubleshooting
PROBLEM CAUSE/SOLUTION
Green Indicator Light is
blinking
• The light blinks to indicate that the iron auto-off function has been
activated.
• To stop the blinking and reset, move the iron back and forth and allow to
reheat.
The indicator light blinks
when in cordless mode
• To stop the blinking and reset, ensure the charging base is connected to
power socket put the Iron onto the base for re-heat.
Iron is not heating • Check that unit is plugged into the Heating Base and that the electrical cord
is plugged into a working electrical outlet.
• Adjust Fabric Select Dial to the correct setting for your garment.
• Verify the auto-off function is not active. Refer to 3-WAY AUTO-OFF
FEATURE section for details.
Iron will not steam • Ensure water tank level is at least ¼ full.
• Ensure steam lever is set to a steam setting.
• Press SHOT OF STEAM button several times to prime.
Iron is leaking • Only ll with water to the Max level.
• SHOT OF STEAM button has been pressed too frequently. Only use in
3-second intervals or less.
• Empty de water reservoir after each use and move Steam Lever to the Dry
setting.
Iron leaves spots/
akes on clothing
• Empty water reservoir completely after each use.
• Clean soleplate when cool with a wet, damp cloth.
• Use self-cleaning feature once a month.
• Refer to the Anti-Calcium Technology section.
• Ensure water cup used to ll the iron is clean.
Wrinkles are not sufciently
removed
• Use SHOT OF STEAM or SPRAY MIST features to help remove stubborn
wrinkles.
• Check that the Fabric Select Dial is set to the correct fabric setting
• Refer to Ironing Tips or visit www.oster.com for more tips and hints.
Fabrics are getting an
unwanted “shine”
• Use an ironing cloth or a 100% white cotton fabric and place it between the
garment being ironed and the iron to prevent “shine.”
GCSTCC5000_22SEPM1 (LA).indd 12GCSTCC5000_22SEPM1 (LA).indd 12 2022/9/14 10:35 AM2022/9/14 10:35 AM