49
The following few basic steps will take you through a pairing sequence:
1. Prepare device
Make sure that the Bluetooth function is turned on in the cell phone or the audio
source. Find the menu or identify the activation required to start the pairing process.
Refer to the manual of the cell phone or audio device to be paired for detailed instruc-
tion on how to conduct the pairing. Normally, it is referred to as “find new audio equip-
ment” and then set up the device as instructed.
2. Set Streamer into pairing mode
Put Streamer into paring mode by a very long press of 5 seconds on the Connect but-
ton until it flashes. Streamer is now in pairing mode indicated by the fast blinking blue
light.
3. Start pairing
Activate the pairing feature on the device. The device is now searching for active Blue-
tooth devices in the area. When Streamer is found by the device, the name ‘Streamer
1.2’ will appear in the display of the device (if featured). Go to the word ‘Streamer 1.2’
and press select or OK.
To Next Page
Loading...