PRODUCT INFORMATION
PULL-FORCE MEASUREMENT SYSTEM POWER-CHECK 2
5 OPERATION
5.1 MANUAL OPERATION
The measured pull-force is read from the display during manual operation. In addition, the measured
value is stored internally and may be logged by an adequate reading device (USB interface).
Activate
press briefly
The battery charging condition is briefly display (bar display 0 - 100%); the
device is operational thereafter
Measuring
Clamp tool
Read pull-force
Pull-force is displayed
Drag indicator display: only the maximum value is displayed and remains
displayed until the clear button is pushed
Adjusting the adjustable range (sleeve position) is possible in a released
condition only → # 4.1 / 17
Storing
press briefly
The current data is stored every time
clear
is pushed. The LED
memory
lights up
briefly
Many thousand measurements can be stored.
Stored data: consecutive number, ID, date, time, measured value [kN], sleeve
position (adjustable range for tolerances)
Deactivate
push 1 second
Otherwise, the power-off function automatically deactivates the
measurement tool after 4 minutes.
POWER-CHECK-2_PE_2015-09
Subject to modification due to technical advance! // 19
[kN]
return
on
usb
bat low
on
clear
off
manual
auto
return
clear
skip
manual
config
memory
only in auto
To Next Page
Loading...