To Next PageTo Next Page
Need help?Do you have a question about the Otto Bock 3R60-PRO ST and is the answer not in the manual?
General| Product Type | Prosthetic Knee Joint |
|---|---|
| Max user weight | 125 kg |
| Amputation Level | Transfemoral |
| Mobility Grade | 2-3 |
| Knee Disarticulation | Yes |
| Stance Phase Control | Hydraulic |
| Swing Phase Control | Hydraulic |
| Material | Aluminum |
| Water Resistance | No |
| Flexion Angle | 150 degrees |
| Activity Level | Moderate |
| Features | Hydraulic swing and stance phase control |
Specifies intended use for prosthetic fitting of lower limb amputations with a polycentric joint.
Details application for amputees with Mobility Grades 2 and 3, up to 75 kg weight.
Details the importance of alignment and steps for bench and static optimization.
Step-by-step guide for bench alignment using an alignment tool and specific measurements.
Instructions for adjusting the 4G235=T Connection Adapter for alignment optimization.
Details lamination process for the 3R60-PRO=KD socket using specific materials.
Step-by-step guide for socket lamination using stockinette, carbon fiber, and resin.
States manufacturer's liability is limited to product use as per document instructions.
Confirms product meets European Directive 93/42/EEC and classification as Class I device.
