9
Accessories for long below-elbow and through-wrist residual limb
• 9S96=40 Chassis (for hand size L/R6¾)
• 9S184=* Chassis (for hand sizes L/R7¼, L/R7¾, and L/R8)
• 506G4=M3x5 Set Screw (for hand size L/R6¾)
• 506G4=M4x5 Set Screw (for hand sizes L/R7¼, L/R7¾, and L/R8)
•
9E94=* Lamination Ring (for hand sizes L/R6¾, L/R7¼, L
R7¾, and L/R8)
The accessories are not included in the delivery. They must be ordered separately.
2 Description
2.1 Indications for use
The Ottobock System Hands –passive– are to be used solely for the
arm components.
2.2 Field of application
The passive System Hands can be used for any residual limb length.
The hands' simple functionality places low demands on the user.
2.3 Safety instructions
Please make your patients aware of the following safety instructions.
WARNING
Risk of accident when driving a motor vehicle. The ability of prosthesis
users to drive a vehicle is determined on a case-by-case basis. Factors
limb conditions, design of the prosthesis) and the amputee’s abilities.
All persons are required to observe their country’s national and state
driving laws when operating motor vehicles. For insurance purposes,
drivers should have their driving ability examined and approved by an
authorized test centre.
For maximum safety and convenience, Ottobock recommends that, at
the very least, a specialist evaluate the need for any adaptations to the
car (such as by installing a steering fork, automatic shift). Risk-free
driving should be ensured even when the prosthesis is not functioning.
To Next Page
Loading...
