Outils Wolf N34BPE - Simple Troubleshooting: Problems and Remedies

78
G
B
SIMPLE TROUBLESHOOTING:
PROBLEMS AND THEIR REMEDIES
Most operating anomalies are due to mishandling or incorrect use of the lawnmower, or
failure to carry out the normal maintenance that we recommend. Below are some simple
ways of identifying malfunctions and correcting them. If the problem persists, we recommend
that you contact your Outils WOLF-approved Specialist (list available on request from Outils
WOLF - 5 rue de l’Industrie - BP 80001 - 67165 WISSEMBOURG CEDEX).
WARNING! Before beginning any work on the lawnmower, switch off the motor and
unplug the power cable.
MALFUNCTION PROBABLE CAUSES REMEDIES
The lawnmower is noisy
and vibrating a lot
The blades have been
damaged by an impact
Replace the blades
(original parts)
The blades are loose Tighten the bolts
The motor is not running
There is no power
reaching the motor
Check the cable
connection and
the fuses
The cable is damaged
Take the plug out of
the socket, replace or
have the cable checked
by your Outils WOLF-
approved Specialist
The lawnmower cuts badly
The blades are blunt
Replace the blades
(original parts)
The cutting height is wrong
Correct the cutting
height adjustment
The grass bag does
not fill properly
The blades are worn
Replace the blades
(original parts)
The bag canvas is clogged Clean the grass bag
The cutting height is wrong
Correct the cutting
height adjustments
outwol_noticeN34BPE_N37BPE_4langues_ref769-08667.indd 78outwol_noticeN34BPE_N37BPE_4langues_ref769-08667.indd 78 31/10/2014 09:5331/10/2014 09:53