Content "R-Tronic" + "R-Con"
4
1. General information 6
2. Safety notes 8
2.1 Intended use 8
2.2 Residual risks and fundamental dangers 8
2.3 Warnings and their meaning 9
2.4 High-frequency emissions of wireless sensors 9
3. Product description 10
3.1 Summary 10
3.2 Technical data 16
3.3 Note regarding declaration of conformity 18
3.4 General conditions of sales and delivery 18
4. Installation and initial operation 19
4.1 General installation advice 19
4.2 Wall attachment of xing plate "R-Tronic RT B / RTF B" (battery operation) 20
4.3 Wall attachment of xing plate with ush-mounted power pack ("RTFC K") 21
4.4 Installation with table stand and mains adaptor ("RTFC K") 22
4.5 Installation and operation of the wireless receiver "R-Con" 23
4.5.1 Fixing of the wireless receiver "R-Con" to the mounting rail 23
4.5.2 Operation of the rotary switch at the wireless receiver "R-Con" 24
4.5.3 Electrical connection of the wireless receiver "R-Con" with actuators 25
4.5.4 Extension of the wireless receiver by further modules 30
4.5.5 Cabling of the logic module with burner and pump 33
4.5.6 Connection of the wireless receiver to the 230 V network 35
4.5.7 Summary connection diagram 230 V and 24 V 36
4.5.8 Use of antenna, extension and wireless repeater 37
4.6 Creation of radio communication between "R-Tronic" and "R-Con" 38
4.6.1 Setting date and time at wireless thermostat "R-Tronic" 38
4.6.2 Adaptation of "R-Con" channels to "R-Tronic" ("teach in") 39
4.6.3 Termination of the radio communication ("teach out") 42
4.6.4 Factory settings control module "R-Con T 2P" 44
4.6.5 Deletion of individual wireless thermostats "R-Tronic" 45
4.6.6 "Emergency operation" of control module "R-Con T 2P" 46
4.7 Controller settings at the wireless receiver "R-Con" 46
4.7.1 Selection of the operating mode 46
4.7.2 Settings at the logic module 50
4.8 Standard heating proles and temperature setting 53
4.8.1 Switching between different heating proles 53
4.8.2 Setting of the required temperature via NOMINAL SETTING 55