NEO 200S 2U Tape Library
getting started
© Copyright 2009
First edition: July 2009
The information in this document is subject to change without
notice.
AL540-96014
IMPORTANT:
The shipping lock must be removed for the robotics to work
properly. A robot move error is displayed if the shipping lock is not
removed. See Step 1, Removing and storing the shipping lock.
WARNING!
The 2U Tape Library weighs 15.6 kg (34.3 lb) without media and 20.4
kg (44.9 lb) with media (24 cartridges). When moving the Library,
to reduce the risk of personal injury or damage to the device:
• Observe local health and safety requirements and guidelines for
manual material handling.
• Remove all tapes to reduce the overall weight of the device and
prevent cartridges from falling into the robotic path and dam-
aging the Library.
• Obtain adequate assistance to lift and stabilize the device during
installation or removal.
WARNING!
When placing the Library into a rack, to reduce the risk of personal
injury or damage to equipment:
• Extend the rack leveling jacks to the floor.
• Ensure that the full weight of the rack rests on the leveling jacks.
• Install stabilizing feet on the rack.
• Extend only one rack component at a time. Racks may become
unstable if more than one component is extended.
Front panel overview
2. Mailslot1. Power button
4. LCD screen3. LEDs
6. Air vents5. Control keys
7. Magazines
Page 1
To Next Page
Need help?
General
