10400370-002 ©2012-16 Overland Storage, Inc. Page 1 of 5
*10400370002*
NEO
®
200s / 400s
Chassis Replacement Instructions
This document describes how to remove and replace the chassis
of a NEO 200s or NEO 400s library from Overland Storage.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working with
the unit.
WARNUNG: Um das Risiko eines elektrischen Schlags oder
Schäden am Gerät zu vermeiden, ziehen Sie stets den
Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT: Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
Prepare the Unit
Save Library Configuration
If possible, save the current configuration of the old library:
1. Plug a USB drive into the rear panel.
2. At the Operator Control Panel, press:
Configure > Save/Restore > Save Library Config.
3. Remove USB drive.
Power Off and Disconnect
1. If possible, use Operator Control Panel to unload drives
that contain a cartridge (
Control > Move Cartridges).
2. Power OFF the library.
3. Disconnect the power cord ().
4. Disconnect all other cables ( & ).
To Next Page
Need help?
General
