Overmax X-bee - Usage, Testing, and Maintenance; Drone Control Operation; Test Flight Procedure; Emergency Stop

EN
Emergency stop:
If the drone is farther than 30 meters and its altitude exceeds 14 m:
Keep the lock key for about 3 seconds. The motors will stop and the drone will be
locked. Do not use this option during regular flight, this option is intended for emergencies!
How to control the drone
To control the drone, move remote control bars in accordance with figures below.
Figures present bars in the default control mode 2.
Fig. 19 A – lift
B – drop
C – fly backwards
D – fly forward
Fig. 20 E – turn right
F – turn left
G – fly left
H – fly right
Test flight
Take the following steps to make sure the drone operates properly.
1. Place the drone in the open space so that both front of the drone and user have the
same direction.
2. Start the drone and controller.
3. Connect the controller to the drone. Perform detection procedure.
4. Run M RC PRO application, enter the camera interface.
5. Unlock the drone.
6. Lift the drone into the air. Test the left/right turn.
7. Make the drone land.
8. Lock the drone.
9. Remote the battery from the drone and switch the controller o.
Phone holder
See: fig. 14
Slide the phone holder out. Lift it by 30 degrees until you can hear a distinctive “click”. Tilt
the protection. Adjust the size of the holder to your phone.