OWC ENVOY DEVICE SETUP
4
3. Insert your SSD into the black SATA connector on the circuit board, as circled in the
picture below. The connector is notched so that it only fits in one orientation.
4. Replace the bottom cover, then use a Torx T5 screwdriver to install the two screws that
you removed in step 1, as circled in the picture below. The longer screw goes on the
left and the shorter screw goes on the right. Remember to be careful when installing
the screws and do not use too much force. If the screws are over-tightened, they could
strip.
5. Remove the backing on each of the adhesive rubber feet and place the sticky side of
each foot in one of the grooves on either end of the OWC Envoy, as shown.
The assembly process is now complete. You can begin using your OWC Envoy right away.
If you need to format the SSD inside the OWC Envoy, see Section 3.1.
To Next Page
Loading...
