3.4 Removing the GUID Partition Scheme
Only for XP, 2000, ME and earlier. (XP 64-BIT, Vista & Windows 7 can continue to the next section)
➆ Type exit and hit enter.
➇ Close the command prompt window.
You may now proceed with formatting the drive.
Your new OWC Mercury Elite-AL Pro is preformatted for use with a Macintosh. Un-
fortunately, this is not readable by Windows without special software. If you wish to
use your storage solution on a computer running Windows, you will need to reparti-
tion and reformat using the following instructions.
➀ Go to the DOS command prompt by selecting “Run”
from the Start Menu.
➁ Type in cmd in text box, and hit the“OK” button.
➂ Type diskpart and hit enter.
➃ Type list disk and hit enter.
➄ Type select disk x replacing x with the number of the disk you want to reformat.
(Typically, you will see an asterisk (*) under “GPT” for the disk requiring formatting.)
➅ Type clean and hit enter.
OWC Mercury Elite-AL Pro Chapter 3 - Formatting
WARNING: The clean command will destroy ALL data on the disk you run it on!!! Be sure there
is nothing you need to keep on your drive before running any of these commands.
WARNING: The clean command will destroy ALL data on the disk you run it on!!! Be sure
there is nothing you need to keep on your drive before running any of these commands.
To Next Page
Loading...
