OWC Mercury Elite-AL Pro Chapter 2 - System Setup
2 SYSTEM SETUP
2.1 Software Installation
The OWC Mercury Elite-AL Pro is plug & play, no drivers required with any modern OS.
2.2 Computer Connections
To use the OWC Mercury Elite-AL Pro, connect any interface cable to the drive and the
computer. Then, turn the power switch to the ON position, and verify the blue LED on
the front of the drive is illuminated.
Your drive should mount on your computer’s desktop.
Your new OWC Mercury Elite-AL Pro is shipped preformatted, ready to use on
any Macintosh system. If you are using a Windows PC, you will need to reformat
the drive to use with your system. Please proceed to section 3.3 and follow the
instructions provided.
ATTENTION: The OWC Mercury Elite-AL Pro utilizes an integrated aluminum heatsink design
enclosure. The enclosure will become warm to the touch during heavy usage.
To Next Page
Loading...
