To Next Page

To Previous Page

OWC Mercury Helios 3

Device Setup

7. Slide the inner-chassis back into the outer-

enclosure as shown above.

8. When the inner-chassis is fully seated into the

outer-enclosure, tighten the thumbscrews on

the rear panel. Press each screw in toward the

enclosure, then twist clockwise while still applying

pressure. Keep twisting until you feel increased

resistance. This completes the assembly process.

Questions and Answers:

Need help?

Do you have a question about the OWC MERCURY HELIOS 3 and is the answer not in the manual?

OWC MERCURY HELIOS 3 Specifications

General