OWIM HG00073B - Preparing the Temperature Station for Use

14 GB/CY
Note: Make sure you fit the batteries the
right way round (polarity). This is shown
in the battery compartment (see. fig D).
The outdoor sensor is now ready for use
and the control LED
28
illuminates briefly.
Close the battery compartment cover.
If this does not work, carry out a restart,
if necessary. To do this, press and keep
pressed the Z
Z
/ REGISTER button
18
.
Preparing the temperature
station for use
Inserting the batteries:
Open the battery compartment
24
on the
back of the temperature station.
Insert two 1.5 V batteries (AA) (in-
cluded) into the battery compartment.
Note: Make sure you fit the batteries the
right way round (polarity). This is shown
on the battery compartment (see. fig B).
Close the battery compartment cover.
Connecting the temperature station
with
the outdoor sensor and the DCF
radio signal:
After the batteries have been inserted, the
temperature station attempts to establish a
connection with the outdoor sensor. This pro-
cess can take a few minutes. The
symbol
flashes. Once the device has successfully con-
nected to the external sensor, the
symbol
stops flashing and the temperature is shown
in the LC display.