OWIM HG07890A-MSF User Manual

13 GB/IE/NI
Setting up the products
ATTENTION: First start the outdoor sensor, then the main station.
If possible, do not expose the outdoor sensor or main station to
direct sunlight. Plane it to a horizontal, level surface or mounting
on the vertical wall.
The main station can be hung by the eyebolt
4
or flip out the
stand
6
to place it on a horizontal, level surface.
Note: Main station for indoor use only.
Starting the outdoor sensor /
changing batteries
Open the battery compartment
21
on the back of the outdoor
sensor by sliding the battery cover
18
in the direction of the arrow.
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
21
.
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The signal LED
17
at the front of the outdoor sensor will briefly
light up. The signal LED will then flash about twice a minute,
indicating wireless transmission.
Starting the main station / changing batteries
Open the battery cover
5
at the back of the main station by
pulling up on the tab at the bottom of the battery compartment.
When changing batteries first remove the old batteries.

OWIM HG07890A-MSF Specifications

General

Brand	OWIM
Model	HG07890A-MSF
Category	Weather Station
Language	English