10
red, which meas it is ready to join the network. If not, please reset it.
2. Set your gateway to permit joining.
3. The power clamp will join the gateway's network automatically and
the LED indicator will go out when successfully joined.
5. Now you can use your mobile app to remotely monitor the home
energy usage.
5
Mounting
The Power Clamp has a mounting bracket for mounting purposes.
1. Use the mounting bracket as the template to mark the two holes on
the wall for installing screws.
2. Screw the mounting bracket onto the wall according to marked
location. Install wall plugs if necessary.
3. Locate the hooks of the mounting bracket and line up the hooks
with the mounting holes on the Power Clamp. Then fit the hooks
into the mounting holes as the picture below. Installation is now
completed.
To Previous Page
Loading...
Need help?
General
