1.Safety Information
Auto Record
1. Congure the parameters: Press the front panel key, press the Auto
softkey.
Press the Point softkey to specify the total number of readings to record. The
range is 1 to 1000.
Press the Interval softkey to specify the time interval between readings. The
range is 15 ms to 9999.999 s.
2. Record data: Press the Start softkey to start auto record. The icon will
show up on the top of the display. Press the End softkey to stop recording, the
data table shows the readings taken. Press or keys to turn the
page.
Note:
Automatic recording function supports switching measurement function.
In auto range, the relay switch may cause jitter, the data at this time is
invalid. It will last about a few hundred milliseconds, and the data acquired in
this period will be marked as "invalid".
When the dual display is enabled, only the reading of main display function
can be saved.
To Next Page
Loading...
